The use of Bricks or Pavers to develop a walkway or patio area complements a house in a method that is unmatched. In addition, setting up a Brick or Paver sidewalk does not necessarily need a pro.
The key to installing a Brick or Paver Walkway is to first properly prepare the area where the bricks/pavers are to be installed. The area needs to be dug out a minimum of a foot down, getting rid of all topsoil and clay soil. In addition, string lines need to be strung on each side of the walkway. The string lines indicate the completed height of the pathway.
As soon as the location has actually been dug, 3/4" gravel stone need to be laid in and tamped down securely. 2" of sand, or stone dust must be spread out over the gravel. Once again the sand/stone dust must be tamped down. Stone dust is preferred. The height in between the tamped down sand and the stringline need to equate to the thickness of the brick or paver.
Now that you have a stable base, place a 1" pipe or journal board the length of the pathway on either side of the walkway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level surface location to lay the bricks/pavers.
Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready location. These strips will act as your pathway border and help to preserve the stability and shape of the walkway.
You can then begin to lay the bricks/pavers as soon as this is done. There are numerous patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again help preserve the integrity of the pathway.
Inevitably bricks/pavers will require to be cut or split when building the sidewalk. To in fact cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you want to break refractory fire brick the brick. If your sidewalk has curves you will need to buy/rent a wetsaw.
After setting up the bricks, construct up the outside edges with extra sand, and after that shovel in the topsoil and pack down strongly.
Spread stone dust over the brand-new walkway and sweep into the check here fractures. This will finish the interlocking of the bricks and assist to eliminate any weed development.
In addition, installing a Brick or Paver pathway does not always require a pro. The secret to setting up a Brick or Paver Walkway is to very first properly prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, put a 1" pipe or journal board the length of the sidewalk on either side of the sidewalk. These strips will act as your walkway border and help to maintain the integrity and shape of the walkway. Inevitably bricks/pavers will need to be cut or split when developing the sidewalk.